Out of stock
Want to be notified when this product is back in stock?
Many Yamaha snowmobile owners received the mechanical diagnostic code Code 12 – Faulty Crankshaft Position Sensor from their on-board computer. This error code indicates that the position sensor connected to the stator is broken and that it cannot send the correct signal to the CDI box, which manage electrical distribution through the vehicle.
The solution proposed by Yamaha dealers is to replace the complete stator at prices around 400$;
Our Crankshaft Position Sensor allow you to replace only the part that is broken without changing the complete stator for 88% less expensive than the dealers solution's price.
All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Used on
| Yamaha | Apex 1000 | 2006 | -2010 |
| Attack 1000 | 2006 | -2007 | |
| Attack 1000 GT | 2007 | -2007 | |
| Nytro 1000 | 2006 | -2007 | |
| Nytro 1000 ER | 2006 | -2007 | |
| Phazer 500 | 2007 | -2017 | |
| RS Rage 1000 | 2005 | -2007 | |
| RS Vector 1000 | 2005 | -2009 | |
| RS Venture 1000 | 2005 | -2017 | |
| RS Venture 1000 GT | 2007 | -2009 | |
| RS Viking 1000 Professional | 2008 | -2015 | |
| RX Warrior 1000 | 2004 | -2005 | |
| RX-1 | 2003 | -2005 | |
| Venture 500 | 2007 | -2017 | |
| Viking 1000 Professional | 2006 | -2007 | |
| Yamaha | YXM Viking 700 | 2014 | -2017 |
| YXR 700 Rhino | 2008 | -2009 | |
| YXR 700 Rhino | 2011 | -2013 |
Replaces the following OE reference numbers
8FA-81410-00-00
8FP-81410-00-00
8FP-81410-01-00
8FP-81410-02-00
8ES-81410-00-00
8ES-81410-01-00
8GC-81410-00-00
8GC-81410-10-00
1XD-81410-00-00
5B4-81410-00-00
Minimal Mechanical Experience Required
N/A
This is a universal pick up coil.
Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
Rotate the fly wheel by hand so the raised node is lined up with the pick-up pulsar coil and adjust as close as possible, but no less than 0.010 inches.
If no spark or erratic spark, switch the wires at the plug.
Using a small soldering iron, weld the wires to the ones on your OEM wiring harness.
Insulate your solders with heat shrink.