Please note : There is two different stators that fits a Yamaha YFM 350 Wolverine 1995-1999. See specification tab for details. PLEASE VALIDATE THESE MEASUREMENTS WITH YOUR OLD STATOR BEFORE BUYING THIS PRODUCT
We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.
*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.
Used on
| Yamaha | YFM 350 Big Bear | 1998 | -1999 |
| YFM 350 Big Bear 2×4 | 1999 | -1999 | |
| YFM 350 Big Bear SE | 1997 | -1997 | |
| YFM 350 Wolverine | 2000 | -2001 | |
| YFM 350 Wolverine California | 2000 | -2000 |
Replaces the following OE reference numbers
4KB-85510-10-00
4KB-85510-11-00
4KB-85510-12-00
Plug-and-Play / Direct Fit
Previous Product Code
AYA4029
Number of wires : 7
Number of terminals : 7
Alternator : White Between each White = 0.9 ohms+/-20%
Alternator : White to Ground = O.L. ON DISPLAY
Source 1 : Green to Black = 300 ohms+/-20%
Pick up 1 : Red to White = 500 ohms+/-20%
PLEASE VALIDATE THESE MEASUREMENTS WITH YOUR OLD STATOR BEFORE BUYING THIS PRODUCT
Inside Diameter : 52 mm
Outside Diameter : 115 mm
Thickness of Stack (Pole) : 40 mm
Before installing your new stator
Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".
